Small storage hack: two‑tier pullouts
A simple cabinet upgrade getting attention is a two‑tier pullout organizer for pots, pans and lids that keeps clutter off shelves and saves digging through stacked cookware. (housedigest.com) Install guides show these fit standard base cabinets and can be a low‑cost way to reclaim wasted deep storage. (housedigest.com)
A two-tier pullout rack is a simple way to turn a deep base cabinet into reachable storage for pots, pans and lids. (housedigest.com) The version highlighted this week is Rev-A-Shelf’s 5CW2 organizer, which uses one upper pullout for lids and one lower pullout with dividers for larger cookware. Rev-A-Shelf says the shelves operate independently and ride on full-extension, soft-close slides rated for 100 pounds. (rev-a-shelf.com) House Digest reported on April 15 that the 11.75-inch model was listed at $99.99 on Amazon with a 4.5-star rating from more than 2,600 reviews. The article said that size is built for a 15-inch-wide base cabinet and measures about 11.75 inches wide, 22 inches deep and up to 18 inches tall. (housedigest.com) The fit matters more than the brand name. Rev-A-Shelf sells the same two-tier design in multiple widths, including a 20.75-inch version for a 24-inch base cabinet, and retailers list adjustable shelf heights between 16.75 and 19 inches. (amazon.com, homedepot.com) The appeal is mechanical, not decorative: fixed shelves waste the back half of a 22-inch-deep cabinet because stacked pans block whatever sits behind them. A pullout brings the whole load forward, so lids stand upright on the top tier instead of sliding across a shelf. (rev-a-shelf.com, containerstore.com) This is also a cheaper upgrade than replacing cabinetry. The Container Store lists pullout cookware organizers from about $58.79 for its chrome roll-out model to $119.99 for a two-tier Lynk Professional Select unit, putting the category well below the cost of new base cabinets. (containerstore.com, containerstore.com) Installation is usually a retrofit, meaning the organizer mounts inside an existing cabinet instead of being built in at the factory. Product listings for the Rev-A-Shelf unit say buyers need to measure the cabinet opening, check hinge clearance and make sure no interior shelf blocks the full-height frame. (amazon.com, housedigest.com) The tradeoff is that the organizer uses most of the cabinet’s vertical space, so it works best in a dedicated cookware bay rather than a mixed-use cabinet. For kitchens where heavy pans already live in a deep lower cabinet, the upgrade is less about adding space than making the space usable. (housedigest.com, rev-a-shelf.com)
